About this 3D model

The Spoolholder is used as a bridge that fits on top of your P1S and X1. By shortening the profile rail it should also fit on top of a P1P. It can hold multiple spools while only one can be used so far. Feel free to add more spools to your bridge. The bridge can easily be lifted off the printer, if you want to open the top glass. Attention: You will not be able to open the glas during the printing process (I have never needed this anyway. Just open the door and you should be fine) No special print settings needed. I used PLA with 100 % infill and 15 % infill for the spool carriers. Additional equipment: 1x Aluminium profile 20x40L I-Type Nut 5 (leght: 400 mm) 8x Slot nut I-Type Nut 5 (according to your Al profile) 8x Bearings 608 ZZ 8x22x7 mm3 8x M8x25 screws 8x M8 nuts 8x M5x10 screws 2x M3x16 screws PTFE Tube (I took the one I have got with the P1S) Any type of tube connector. I have used: https://makerworld.com/en/models/26116#profileId-22523 It's a bunch of equipment, but you can use it for multiple other models. I recommend you to buy a screw set. Contact me for any questions.