About this 3D model

This is a replacement belt clip for Sony Walkman WM-EX10. I forgot to enable support when printing. Now the thin parts look a bit messy, but work fine. However, printing with support is advised. Initially, I tried to fit Awesome_Sauce 's Design but it does not fit my specific model. Scaling his model did not work for me, as increasing the space between the rails from 20 to 22mm, results in the thin splints to be too wide. We ended up remixing his model in CAD. The replacment clip might also fit other models, but I did not get the chance to test it. Check if the inner rails on your Walkman are 22mm apart, as they are on my Walkman.