About this 3D model
Modular Lithophane Frame The creation possibilities are endless with this modular Lithophane Frame ONLY USES 8mm LED strips Width & Height Informaiton: Please when printing/creating lithophane use the following measurements: Width or height minimum: 86mm Max 226mm in multiples of 20 Height Width 86 106 126 146 166 186 206 226 86 46mm 66mm & 46mm 86mm & 46mm 106mm & 46mm 126mm & 46mm 146mm & 46mm 166mm & 46mm 186mm & 46mm 106 46mm & 66mm 66mm 86mm & 66mm 106mm & 66mm 126mm & 66mm 146mm & 66mm 166mm & 66mm 186mm & 66mm 126 46mm & 86mm 66mm & 86mm 86mm 106mm & 86 mm 126mm & 86mm 146mm & 86mm 166mm & 86mm 186mm & 86 mm 146 46mm & 106mm 66mm & 106m 86mm & 106mm 106mm 126mm & 106mm 146mm & 106mm 166mm & 106mm 186mm & 106mm 166 46mm & 126mm 66mm & 126mm 86mm & 126mm 106mm & 126mm 126mm 146mm & 126mm 166mm & 126mm 186mm & 126mm 186 46mm & 146mm 66mm & 146mm 86mm & 146mm 106mm & 146mm 126mm & 146mm 146mm 166mm & 146mm 186mm & 146mm 206 46mm & 166mm 66mm & 166mm 86mm & 166mm 106mm & 166mm 126mm & 166mm 146mm & 166mm 166mm 186mm & 166mm 226 46mm & 186mm 66mm & 186mm 86mm & 186mm 106mm & 186mm 126mm & 186mm 146mm & 186mm 166mm & 186mm 186mm Use https://lithophanemaker.com/ to create the lithophane using the following parameters Resolution: Anything Width: See width and height Info Height: See width and height Info Depth: 3.75mm Base Height: 3mm Overhang Angle: Any Maximum Thickness: 3.0mm Minimum Thickness: Any Print the correct parts depending on your image. Use inner frame connectors for the inside of the frame. Use outer frame connectors for the outside of the frame. Border connectors are for corners, 3 way and 4 way splits. Use the 3 Way dual sided if youd like to have 2 different sized images next to each other. Connect each frame together and insert your lithophane panel. You might have to connect or disconnect some to get it to all come together. LED runners need to be in the max dimensions (If you have a 206 x 166 picture use the 206 or 166 LED strip runner.) To add LED lights use the 8mm ONLY led lights by running them through the hole in the LED runner and across to the other side of the frame and through the hole again. As shown below