About this 3D model

as requested. i will keep this listed as a work in progress until some one tells me it will print. I give it about 50% chance on a well calibrated machine with out support (about 95% sure i could print it with support) . this model is 12mm longer then previous versions so LM10uu's will clear the nozzles heat sink. all the same parts except the fan holder will work with it. this was a request job. i don't use budas so i dont need one. also the hole in the middle is exactly 40mm it may require some "finesse" to make the nozzle fit. I tried 42 but it just wasn't going to be printable at all like that.