About this 3D model

All our ideas are truly born right on the printer. And as the light bulb symbolizes ideas, the printer is our idea generator. That’s where the idea behind the printer idea lamp came to become! Lamp used for this model: IKEA STRÅLA, 3cm diameter, 6cm height, 4m length. Bottom part print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 1 hours and 37 Minutes Amount of material required: ~ 22.3 m Back side print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 1 hours and 44 Minutes Amount of material required: ~ 23.8 m Top part print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 54 Minutes Amount of material required: ~ 11 m Middle joint print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 26 Minutes Amount of material required: ~ 4.2 m Front beams print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 26 Minutes Amount of material required: ~ 4.6 m Build plate print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 48 Minutes Amount of material required: ~ 10 m Lamp holder print settings: Supports: NO Brim: NO Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: 1 hours and 13 Minutes Amount of material required: ~ 12 m TOTAL PRINT TIME: 7 Hours and 8 Minutes TOTAL PRINT MATERIAL: ~ 87.9 m