About this 3D model

IDEA – Lamp Hanging version A simple, fast print but yet a cool decorative lamp! Perfect for on a shelf, your desk or night stand. Check my profile for a standing version! Only 1,5 hours of printing ~15 grams of plastic. Requirements: 38mm tea light Glue 5x5mm cylinder magnets 3x White PLA Grey PLA (other colors possible) Assembly: Push the tea light in the “Fitting” . If the tea light is to loose use some tape around the edge of the light to make the fit a bit tighter. (If you have a slightly bigger tea light, send me a message and I will give you a modified version.) Glue the 3 magnets in the “ Fitting ”. Make sure that the poles of the magnet point in the same direction. Connect the “Bulb” & the “fitting” WITHOUT GLUE! Done! (Don’t forget to leave a picture of your results!)