About this 3D model

Version 2: Raised from frame mounting position for slightly better viewing with high print bed slightly tighter fit on frame Resized to fit the side of the heatsink! Store it with your other heatsinks and less likely to forget to swap on nozzle change Included 3 nozzle holder for other 3 sizes I kept forgetting that I changed my nozzle to 0.8 or 0.6 and would send print from my SD card. The print would proceed even though I've told the printer the new nozzle size installed. That check only seems to work when printing direct from Maker World. "You have installed the 0.6 nozzle but this profile requires 0.4" something like that. So, I created these Nozzle Signs The clip into the printer on the inside frame really easily. Great clearances all around. Easily seen by the on board camera. Especially if placed forward enough. 15 - 20 minutes depending on if you do start up print stuff and only 4g of filament for all 4.