About this 3D model

Miniaturized Kyber Crystal Storage Unit modeled after the one used in Savi's Workshop, this unit will securely hold 6 Kyber crystals. Overview Hold and store your kyber crystals with this convenient storage unit. The container features a simple snap-together assembly, making it easy to use and quick to print. Parts count: 10 Key Features Holds 6 Kyber crystals Model assembles easily and snaps together Simple and quick print Printing Details Recommended filaments: eSun PLA+ Black eSun PLA+ Orange eSun PLA+ Silver Hotend: 0.4mm Hardened Steel Print time: 5hrs Printing Tips: - All parts except the top ring & center frame can be printed successfully using the provided print profile and no supports. Assembly Follow the steps below to assemble, I would suggest using a small amount of glue for permanent fixture but the model holds together without. Insert 12 M9 closed rubber grommets, to the holes in the outer fames. Press the center frame into the outer walls. Press the center assembly in to the base. Take the top ring and the silver overlay Press the overlay ring over the top ring, this is a tight fit so go slowly, once at the bottom twist until it seats into the recess. Press the top ring on top of the center assembly. Place the orange cap on the top ring. Push the handle uprights through the orange cap and into the top ring. This will secure the orange cap in place. Finally push the handle crossmember on top of the handle uprights.