About this 3D model

Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Used the head to design a mask Used the hand to design a new one As the original DUMMY13 is no longer available on MakerWorld, you can find assembly instructions for DUMMY13 here: https://www.printables.com/model/593185 Description DUMMY 13 loves COMIC CON! So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON". The aim is to preserve the charm and simplicity of Dummy 13. Content of Spider-DUMM, sorry Spider-Man: Mask for a white head Armor with logo Other parts are standard parts that are just printed in different colors (see pictures) Spider-Man shooting hands Logo: You get the best results for the logo with a 0.25 mm nozzle and lowest layer height . The logo is glued on and the hole in the armor helps with positioning. When gluing, make sure NOT to use any glue that attacks the material and leaves an ugly white stain. Personally, I got the model right on the first attempt. With a little skill and patience, you will also succeed. MASK: Use brim. Slide the head into the mask and press it in with gentle force on the chin. Check the inside to see if it has been printed cleanly and remove any filament debris that is sticking out Has the brim been removed cleanly? The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife