About this 3D model

For all Bambu Studio users or anyone who can use a 3mf file, I recommend using the attached 3mf file, as the 3mf file is pre-colored and pre sliced with the pause for the magnets. If you use the attached 3mf file in bambu studio the printer will pause at the correct layer to place the magnets, at which point you put the magnets into the decks, while they are still on the printer. I have found it easiest to hold the magnets in a stack and put the stack into the hole and slide the stack off into the next hole. Place 8 magnets into one deck and flip the stack of magnets and repeat the process with 8 magnets in the second deck. Resume printing and the printer will print over top of the magnets and you will be ready to fidget as soon as the model is done printing. If you have not printed a KickFlip deck yet and you are wondering about magnet placement please check out this post https://www.patreon.com/posts/kickflip-magnet-121228896?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link There are 8 (8x3mm) Magnets embedded into each deck. The magnets can be purchased from Amazon using this link https://a.co/d/7JcvStJ ALL models INCLUDING the crate are printed with NO Support material. All of these models are printed on stock Bambu Labs X1C or P1S printers using the standard 0.04mm nozzle and a 0.16mm (Maximum) layer height. I use the 4 Color AMS system to print the models in color. Filaments: Eryone Yellow/Green Co-Extrusion Silk PLA Please let me know if you have any questions. Thank you! Mike