About this 3D model

Calvin and Hobbes, from the comic strip by Bill Watterson. The comic strip Calvin and Hobbes follows the humorous antics of Calvin, a precocious, mischievous and adventurous six-year-old boy, and Hobbes, his sardonic stuffed tiger. The full model is built using individual models of Calvin and Hobbes, therefore I created three separate uploads: For the final build using the individual Calvin and Hobbes models see: https://www.prusaprinters.org/prints/143447-calvin-and-hobbes (this upload) For the Calvin model see: https://www.prusaprinters.org/prints/143455-calvin For the Hobbes model see: https://www.prusaprinters.org/prints/143475-hobbes No supports are required. If you have the right filament colors, no painting is needed. The fully completed model is 250mm tall after assembly. Enjoy! --------------------------- Colors (there are no multiple printed pieces) Brown: log Printing and assembly tips 1-No supports are required. .. 2-Be sure to use at least five top layers for the log for a clean finish. Assembly tips: -Build the Calvin model and Hobbes model using the links provided in the introduction. -The assembly diagram will help in assembling the model and is quite straightforward. -The model is meant to be glued together.