About this 3D model

This is a remix of DjangoCashflow's design - https://makerworld.com/en/models/173835 It's a great pill organizer design, three clicks to move between days and it stays locked in place quite well. I printed this for a family member with wrist issues so wanted it to be fairly easy to turn. I wanted a clean top, so the Bambu logo has been removed. I had some sizing issues where the internal fins were a bit too long so it was very difficult if not impossible to twist, which created a scenario where the whole fin structure could break off. The screw size was a bit big for the threading as well. After a few iterations these modifications have made it turn out very nice: Fin sized reduced, it now turns with a reasonable amount of effort while still staying locked into place and maintaining its clickiness Fin structure strengthened with a bit more material at the bottom (hidden after assembly) Screw width reduced from 9.5 to 9.0mm Assembly is intuitive, use a jewelry flathead screwdriver to install the screw.