About this 3D model
“Flue Brogg” artwork by Dall-e on my prompt. I splitted the frog from the background and tinkered a bit to cut a hole in the eye, actually the yellow layer belongs to the background. Instead of making a multipart which is overcomplicating the thing and underexploiting the sofftware… I just made a hueforge for the background with green/soil tones peaking in the yellow, and it lasts at height 1.28mm. Then I worked on the frog alone, on a .png of the same siaze of the background. I set into Hueforge to have a min depth of >1,28mm and went for it with black and blues over it, peaking with a very low TD white. I imported both file simultaneously in Bambu Studio and told to consider them as a single object made of 2 parts, when prompted. The result is a cool painting style hueforge plate, the back layer is thin as rice paper and as my style I overexagerated the color palette. Two times, this one. It's practically irreproducible unless you get the same colors with the same TDs, but if someone would like to remix the colors throwing the .stl file in his Hueforge it would be cool to see it turn to something viable in just 8 colors, or even a complete psycho new color mix! :) Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA SunLu Black Transmission Distance: 0.9 PLA Amazon Basics Dark Brown Transmission Distance: 6 PLA BambuLab Basic Green Transmission Distance: 3 PLA GEEETECH Brown Transmission Distance: 6.6 PLA Amazon Basics Pea Green Transmission Distance: 3.5 PLA Sunlu Orange Transmission Distance: 6.6 PLA Amazon Basics Yellow Transmission Distance: 3.8 PLA SunLu Black Transmission Distance: 0.9 PLA Amazon Basics Dark Brown Transmission Distance: 6 PLA Amazon Basics Blue Transmission Distance: 9 PLA Amazon Basics Light Blue Transmission Distance: 3.6 PLA Bambulab Basic Cyan CMYK Transmission Distance: 6.6 PLA SunLu White Transmission Distance: 6.6 PLA Amazon Basics White Transmission Distance: 2.7 Swap Instructions: Start with Black At layer #4 (0.4mm) swap to Dark Brown At layer #5 (0.48mm) swap to Green At layer #6 (0.56mm) swap to Brown At layer #7 (0.64mm) swap to Pea Green At layer #9 (0.8mm) swap to Orange At layer #12 (1.04mm) swap to Yellow At layer #15 (1.28mm) swap to Black At layer #17 (1.44mm) swap to Dark Brown At layer #18 (1.52mm) swap to Blue At layer #20 (1.68mm) swap to Light Blue At layer #23 (1.92mm) swap to Cyan CMYK At layer #25 (2.08mm) swap to White At layer #26 (2.16mm) swap to White 2.7 TD for the rest.