About this 3D model

my profile is the .08 layer height for best finish on outside of the box but a .2 layer can be used just fine if the finish isnt a issue for you to speed the print up a simple easy print to showcase your lithophane pictures also has a notch in bottom right to use a pick or screwdriver to remove and swap the image easier light sourse used: https://www.aliexpress.us/item/3256804809925722.html?spm=a2g0o.order_list.order_list_main.48.5cdf1802GSzioa&gatewayAdapt=glo2usa (ones used are the 20 led version labeled 20pc) a simple led strip may also be used around the walls as well. using a m3 screw it can be attached to the back wall of the box and a micro usb cable can be run through the hole in the back to a power sourse of your liking.