About this 3D model

Works well and the kids love it. I printed this with no supports without any issues. I specifically tried to design the breather hole to avoid supports. The printer should have no issues bridging the gap. I did apply some wood wax oil with a small paintbrush to the bottom compartment DURING PRINT to make the teapot water tight. Not sure it's needed, but I had wax laying around and decided I'd try it and it's not leaking :) It's also possible to add a liquid sealant post print! As you can see in the pic, the fluids are visible through the PLA, maybe try increasing to three walls or print in darker colors. I ended up spray-painting this print.