About this 3D model

Servo cutter v2 see: https://makerworld.com/zh/models/379140 Specific test see Bilibili 【Voron SB head servo cutter test】https://www.bilibili.com/video/BV19A4m157Jf?vd_source=c7e963c712fcfe6c78b672060f20e54b Project address https://github.com/tdft/Stealthburner-CW2-Stealthburner-CW2-servo-cut-tip Traditional nozzle cutters use the nozzle to hit the collision block to cut off the filament, which easily leads to xy motor lost steps, even if the material is cut and then returns to zero, the repeated positioning accuracy of returning to zero will cause layer lines, and it will also reduce some printing travel, using servo cutters perfectly solves the above problems, no problems have been encountered through multiple blunt knife tests and printing tests. The servo can use es08md, mg90s.