About this 3D model

Each side has (5) 8x3mm neodymium magnets placed inside after a build pause. Remember to reverse the magnet polarity between the two sides. The attached 3mf file has the pause included at layer 30. I highly recommend using the Attached m3f file, I slowed down the outer wall and top surface speeds a little bit, which results in a much nicer and much shinier surface finish. Also for the best movement and fidgeting experience I highly recommend printing these on a textured build plate. The magnets I used were purchased from Amazon, link below…. https://linktr.ee/mzmdigitaldesign These were printed on a stockBambu Labs X1C and P1S 0.4mm nozzle 0.12mm layer height Infill: 60 As always please let me know if you have any questions! Thank you! Mike