About this 3D model

Boost Me Your boost on MakerWorld means a lot to me! If you like my design, please support me with a click. ? The box is easily printable with correct settings and a well-calibrated printer. I am not responsible for printing errors such as "spaghetti" due to lack of adhesion or fused hinges due to incorrect printer settings. This practical Print in Place box was specially designed for 3D printing without much post-processing – no assembly required! All hinges are already integrated and move freely after removing the support structures. The box is ideal for storing small parts, screws, SD cards, office supplies, or other utensils. The lid closes flush and stays securely in place thanks to the stable hinge construction. Technical Data: • Overall dimensions: 13.6 × 10.5 × 7.5 cm • Print type: Print in Place (no assembly needed) • Recommended layer height: 0.24 mm • Material recommendation: PLA or PETG Caution: Since the model is printed with the open side facing down, extensive support structures are required, especially under the inner compartment. While this results in longer print time and some post-processing when removing supports, it guarantees clean hinge function and a stable overall construction. Please note that different filament brands and materials can influence tolerances. As a result, parts may be slightly too loose or too tight, or the hinges may fuse. Some support structures - particularly in the hinge area - may be difficult to remove depending on print settings and material, and require some care. Please ensure your print bed is clean and correctly leveled