About this 3D model

- Complete new and own design, therefore different from any other capsule holder on thingiverse - Small amount of material needed (it's very cheap) - Therefore fast printing time (you can make a lot of them) - 2 parts to be combined with dovetail (for perfect alignment) - Optimized capsule movement through elevated sliding rail (bulge on the flat side does not lead to stuck capsules) - Ability to take out capsules at the bottom - Space for 10 capsules - Printing footprint: about 18x10cm Note: This part is not an official Nespresso part and does not stand in any relation to Nespresso.