About this 3D model

Test Block 2 A simple geometric test block i use to test Extrusion/Heat/Overhang Ratio along side ironing.Also give's a good idea of resolution over curve's and angle's. Approx 30mm x 30mm x 20mm. If calibrated properly will give nice clean sharp edges and smooth to surface. If calibrated poorly.. Droop's on lower side sphere = Too hot or Over ExtrusionLoss of definition at top of triangle = Too cold/ Under ExtrusionUneven/patchy top surface = Under Extrusion Probably...Lump on Far side square corner = Over Extrusion This object was made in Tinkercad. https://www.tinkercad.com/things/gAvrg1f8vvp