About this 3D model

This is another version of my 18650 battery box! There are two print profiles. One for flat top batterys and one for button top batterys. These are flat top: These are button top: Recommended filament: PLA Hotend: 0,40mm Print time: flat top 1:30h / button top 1:50h Print instructions: order of walls “outer /inner” walls “detect thin walls” speed outer wall “60mm/s” layer height 0,20mm 2 wall loops top/bottom shells 4 layers top/bottom shell thickness 0,80mm sparse infill 10% sparse infill pattern “gyroid” Before printing , make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints. Bad build plate adhesion is not related to the model. Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!