About this 3D model

Boost Me Consider boosting if you liked this design! :) UPDATE 5/12/2024: Edited to remove that little bottom nudge that caused some wear on the screw holes of the joycons! UPDATE: Fixed a difficult overhang that caused print failures in the honeycomb model! EDIT: Added another version: the body has been emptied and honeycomb pattern holes on the surface, print with supports as in the pictures! Remix of Nintendo Switch Portable Comfort Grip by Halasox ( https://www.thingiverse.com/thing:3440526 ). The original design was great but it lacked of a way to disconnect the joycons from the console, so I added a hole and a pin in order to press the button. Supports are needed only in the 90° overhang that supports the bottom of the joycon, so you can add support blockers in any other place. That part and the bottom of the handle always printed with a rough surface even with support interface enabled (see last picture) and I wasn't able to improve it, so if anyone has suggestions please comment! slightly The STL files are for the left JoyCon but you can mirror it in your slicer to obtain the right one (same goes for the pin since it is slightly asymmetric ). There are two types of profile: Snappier fit : The grips have a small bump in the bottom part that snaps in the bottom internal screwhole and makes the grip less likely to slide off. Beware that this may cause some wear/discoloration on the screwhole. No bottom nudge : The small bump has been removed, the grip will feel looser, but the wear on the screwhole is avoided. When importing to the slicer select to import as object with multiple parts, if prompted. Print the pin vertically (rounded top up) and keep the same orientation of the STL for the Grip body. To assemble, insert the pin from the front of the grip by forcing it inside the hole, the rounded tip should slightly come out of the back side (where your fingers will rest). Once through, it should not fall out. Printed on Anycubic Kobra Neo @ 0.12mm layer height and 45 mm/s speed. Print Settings Printer Brand: Anycubic Printer: Kobra Rafts: Yes Resolution: 0.12mm Infill: 40% Filament: Sunlu PLA Black Category: Video Games