About this 3D model

printed on the creality K1 with pla (strong enough but be carefull of the holds when you drop it on a hard floor because they will most likely break!) Things you need: 32 thread inserts (M3x6) 32 bolts (M3x10) Soldering iron to apply the thread inserts Superglue Tips: I printed some holds with fuzzy skin to get a better grip The holds (1.1-1.4 ; 5.1-8.1) are the easiest to begin with, the other ones are harder to grip. make sure the connector fits inside completly, otterwise I advice to print in a little smaller so there won't be a gap when you connect to 2 halfs.