About this 3D model

Japanese-inspired desk lamp with kumiko inserts that fits LED puck light fro Bambu (LED lamp kit 001). There are multiple side and top panels to choose from. Printing Print the frame and top and bottom build plates in your color of choice. Bambu PLA Matte Latte Brown and Matte Dark Brown are shown. I printed these parts on the Smooth PEI Plate to make all sides mostly uniform. For the light panels, four can be printed at a time on the P1/X1 build plate if you arrange them like you see below. Pick the one you like and make 3 clones or mix and match. Either print in all white or print the design in your frame color. Assembly The eight pegs slide into the eight slots in the frame. There are two types of shorter side frame pieces. The ones with long rectangular slots go on the bottom to accept the lower plate the LED sits in while the pieces with two lips goes on the top. Orient the top pieces so the thicker lip is toward the inside. Insert the LED light before assembly to make things easier. Insert the eight pegs into the slots on both larger frame pieces. Attach bottom short side frame pieces to bottom panel with LED first, then slide that sub-assembly onto the large frame. Insert top short side frame pieces onto the same large frame you put the bottom panel on. Take the other large frame and connect to the rest of the assembly. Press to fit. The side panels are easiest to install if you insert the bottom side first and then press fit the top. There is a lip to hold them in, so some flexing may be needed but they should snap into place. Insert the top panel into the top square frame piece and drop into the slot.