About this 3D model

Here I have a PLA profile for beginners with a picture of the printed part You can use this if you have problems with adhesion I only use this profile for white PLA Because I print colored filament differently The cube from Bambu Lab was printed on the black Tex Pei and there have never been any problems with this profile Therefore it would be good if you clean your black Tex Pei plate before use with iso or with warm water and dish soap but without additives Good luck Also check out my profile there I have many Hueforge pictures as well as other models And if anyone has problems please send me a private message here on MakerWorld then I will help immediately