About this 3D model

I was not happy seeing how the cable on the extruder was hitting the Z-Rods and the Top-Bar while homing X and while printing near Z-Max (with the original cable clip the cable touches the top bar at around z=20cm. So it was time for my first design(s) in FreeCAD… Version 1 almost satisfied me, but maybe somebody wants it (so i upload it as well). The Cable needs to be folded to fix it with a cable tie. This version would work when you change the homing position for the X axis e.g. by blocking it from going too far to the left side. Version 2.1 fixes the Cable at angle and tilted 90° so it flexes easier while printing and doesn't touch any obstacles while printing (the right Z-Rod should not be a problem). Just mount the version you like using the original screws and fix the cable using a ziptie to it (like you can see in the pictures). The cable has some flex so it can easy be bent to shape - do not push it onto the back of the extruder-PCB too hard (the soldered pins should not touch or penetrate the insulation on the cable - you can put kapton tape over the pins just to be sure). UPDATE: Due to easy breaking of PLA-parts I reinforced the design a bit and uploaded Version 2.2 . If you are able to print ABS or PETG, do so for this part. Prints without support. Take a look at my Collection of parts for the Artillery Sidewinder X4: Artillery Sidewinder X4 Mods by waintdeir | Collection - Makerworld Consider leaving a ? Like and a ⭐⭐⭐⭐⭐ rating and upload a picture ? I hope to help somebody with my solution. If you have any further suggestions, feel free to contact me.