About this 3D model

Ender s1 gantry light bar. im sure it will work on a pro. Screws right into the existing hex screws on the back of the gantry. I used a 24v led strip and soldered - and + wires and ran it into the black loom right at the clip on the Z rod. Then ran it to the power supply - and +. Added a rocker switch to the front bezel. If installing the rocker switch in the same location that i used. try installing it as high as possible because the connector on the mother board was almost in the way. I had to bend the tabs on the rocker switch up. please leave ⭐ review and rate. Buy me a some raman if i helped you out in anyway. https://ko-fi.com/3deeznutz Check out my other designs. https://cults3d.com/en/users/3DeezNutZ/3d-models https://www.printables.com/@3DeezNutz_752861/models