About this 3D model

This is a bit of embellishment for the P6*6 3D printed pinhole camera. http://www.thingiverse.com/thing:157844 I dislike the flat, unfinished aspect of the front face of the extension on the P6*6, so I made a face plate for the "Shutter Clamp". Designed to NOT vignette the image projected onto the film, this needs to be securely glued in place, as popping the cap off exerts a small leverage on the trim ring. At this writing, I have used Super Glue to good effect. For proper fit, the outside perimeter of the trim ring may need to be slightly sanded or smoothed with acetone - not too tight or too loose! Additionally, the cap protects the film from accidental exposure if the shutter should get knocked open. Previously, I have been using a bit of gaffer's tape. ___ **ATTENTION** This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing. **All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download** This notice constitutes a clarification, not a change, to licensing for this design.