About this 3D model

This is my xl photobox! You can take pictures of bigger models and you don’t need to worry about the background! The model consists of: 10 parts bottom: left and right first row: left, left backside, right backside, right side second row: left, left backside, right backside, right side Tools needed: your preferred glue I personaly use “UHU Hart” glue to glue pla parts together. It works best for me and leaves no residues. Assembly instructions: Glue the parts together according to the assembly instruction. Make sure you keep the right angle at the corners. Recommended filament: PLA Hotend: 0,40mm assembly time: 10 minutes Print instructions: layer height 0,20mm 2 wall loops top/bottom shells 4 layers top/bottom shell thickness 0,80mm sparse infill 10% sparse infill pattern “gyroid” brim type “outer brim only” Before printing , make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints. Bad build plate adhesion is not related to the model. Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!