About this 3D model

This is a remix of sencio_madera's original post. It has been cut to fit a smaller bed. You will need to print four long pegs and two short ones. You will also need 5x M3 lock nuts and 2 M3x25, 2 M3x40, 1 M3x35 bolts. Use superglue or epoxy on the A and B parts. You might have to trim down the notch on the inside of the connector for a good fit. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: .2 Infill: 10% Filament: California Filament PETG Purple Notes: use 5 walls for strength Category: Sport & Outdoors