About this 3D model

Update 11/08/24: I have released version 2, it can be found here. https://makerworld.com/en/models/768730#profileId-704226 _______________________________________________________________________________ Update 10/14/24: I added a discreet logo and open ended version of the locking nut. Just download my original profile and they will be on separate build plates. _______________________________________________________________________________ I needed an adapter to fit my Prusament spools on the A1 AMS Lite. Prusaments spools are too small to fully fit on the AMS. They get stuck just as they come in contact with the AMS rubber feet. With this adapter, the adapter grabs snuggly onto the rubber feet and the spool stays in place with the nut. No cutting, no transferring your Prusament filament over to spools that fit. *I uploaded a longer nut to accommodate for Matter Hacker spools with 51mm center holes. Installing spool: 1ST install the shaft into the prusament spool, slightly squeezing the shaft until it pops out the other end. Then slide the spool onto the AMS Secure nut onto the threaded spool holder To remove, repeat steps in opposite order. !! IMPORTANT !! : The shaft MUST be printed with 5-6 perimeters/wall loops!! It may break if you don't. Settings: PETG 15% Infill 6 perimeters/wall loops Boost Me Like my designs? Do you have a couple extra boosts but not sure where to use them? Hit my boost button!! I would really appreciate it!