About this 3D model

Designed by me, turned into 3d using hueforge printed in two parts on p1p in pla to make a larger print, but have also included the one print bed design (small) there are no connectors, i just used velcro command strips on the back and lined it up on the wall instructions below, you can sub for any black and white filament or use any colours you have on hand happy printing Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA PolyTerra Charcoal Black Transmission Distance: 0.3 PLA PolyTerra Cotton White Transmission Distance: 2.5 PLA PolyTerra Cotton White Transmission Distance: 2.5 PLA PolyTerra Cotton White Transmission Distance: 2.5 Swap Instructions: Start with Charcoal Black At layer #7 (0.64mm) swap to Cotton White At layer #12 (1.04mm) swap to Cotton White At layer #18 (1.52mm) swap to Cotton White for the rest.