About this 3D model

Designed and converted to 3d with hueforge 13/10/24 - Updated as noted base was quite thin, also edited the base to print at a higher layer thickness to speed up print time. Use whatever colours you like, please share some photos if you do! instructions as below Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA PolyTerra Charcoal Black Transmission Distance: 0.3 PLA PolyTerra Fossil Grey Transmission Distance: 0.3 PLA PolyTerra Cotton White Transmission Distance: 2.5 Swap Instructions: Start with Charcoal Black At layer #32 (2.64mm) swap to Fossil Grey At layer #35 (2.88mm) swap to Cotton White for the rest.