About this 3D model

Inspired by: Spinning Filament Swatch Display - Lifts Swatches from Brad - FTBT 3D - MakerWorld , but my Voron0.2 can't print it because it's too big. Considering that there might be other friends like me who don't have a large 3D printer, so I designed this Spinning Filament Swatch Display-Mini, but it can't hold all the Bambu Lab filament swatches. The inspiration comes from: Spinning Filament Swatch Display - Lifts Swatches from Brad - FTBT 3D - MakerWorld , but my Voron0.2 can't print it because it's too big. Considering that there might be other friends like me who don't have a large 3D printer, so I designed this Spinning Filament Swatch Display-Mini, but it can't hold all the Bambu Lab filament swatches. !!! Multicolor new version: https://makerworld.com/zh/models/729164#profileId-660704 !!! New multicolor version: https://makerworld.com/zh/models/729164#profileId-660704 Print Settings: Top Layer Height: 0.20mm Bottom Layer Height: adaptive or 0.10mm (for smooth ramp) Top & Bottom Surface: Concentric Print top upside down Use Arachne wall generator for best results As designed it will only turn clockwise, mirror base to turn counterclockwise For best turning: Sand the ramp smooth with 220 grit sandpaper if needed Put rubber feet on the bottom so the base won't spin while turning the top Print Settings: Top Layer Height: 0.20mm Bottom Layer Height: adaptive or 0.10mm (for smooth ramp) Top & Bottom Surface: Concentric Print top upside down Use Arachne wall generator for best results As designed it will only turn clockwise, mirror base to turn counterclockwise For best turning: Sand the ramp smooth with 220 grit sandpaper if needed Put rubber feet on the bottom so the base won't spin while turning the top