About this 3D model

Boost Me It's absolutely free to boost this model and is an amazing way to support my design work! Your boost is greatly appreciated and please leave a comment showing off your print and leave some feedback too about my designs, or any future ideas for designs you may have. Check out my page for more designs like this one if you love my work! I use this model to mount and display my (airsoft) toys that use 9mm Glock magazines. This particular variant is for AR9. I created this model because I was tired of laying my (airsoft) gun on my desk for cleaning, or modifications. This stand was inpsired by other Glock handgun stands I tried that just were not balanced correctly to hold up my bigger and heavier (airsoft) guns. This stand allows me to display the (airsoft) gun on my desk or shelf. I also added mounting holes for screws and currently use a few of these prints to hang the (airsoft) guns on the wall for ease of access. When desiging, I noticed that I needed to really add a lot of support inside glock magazine to support the (airsoft) gun especially when mounted on the wall. As such I recommend when slicing you should add more perimeters to the model and use about 25% gyroid infill.