About this 3D model

Just another silica container that fits inside the Bambu Lab's spool. I modified this because some of my silica gel fragments would fall out in others that I have tried using. I also had problems with others being thin and breaking if dropped. I liked the design of this and its sturdiness. I recommend printing in PETG so you can just put this in a filament dryer with silica for drying. I hope you enjoy my adaptation. As I get time, I will be uploading other manufacturers spool sizes. This work is not a remix but is based on the following: Silica gel container by Kleptocrat NOTE: Attribution was not required but I felt I should anyway.