About this 3D model

I had a bunch of 5mm x 2mm magnets laying around and wanted to find a use for them. I also wanted to print a plant pot that used vase mode to reduce the amount of filament used. This combines them both. Top portion requires vase mode at 1mm width . Changes to this i would test - as 1mm width has a snug fit for me. If you choose not to glue the top on, it makes this print flexible where you can swap out with new designs from time to time. (Although risky if you pull it off by accident with dirt in there..) Also I liked printing the bottom portions in a different color. Bottom portion i did 10% infill and printed as normal. Then super glued magnets in. I personally also super glued the vase mode piece as well. I've only been 3d Modeling for a month at this point, so feel free to leave constructive feedback