About this 3D model

This wave pattern lamp is designed to work with E27 light bulb socket. A short guide on how to print the model: - 010324-01-001-BODY - use support material for the lower surfaces of the lamp (see an attached image), the pattern does not need to be supported at all, - 010324-01-002-BASE - do not use support material, print the part with the "sacrifice layer" and cut it out during the assembly of the lamp, - 010324-01-003-CAP - use support material for the internal flange (see an attached image), - 010324-01-004-DIFFUSOR - print in vase mode (1 perimeter, without a seam), - 010324-01-005-TOP DIFFUSOR - no special requirements, No glue or screws are required to assembly the lamp - just print the pieces and put them together (the parts were designed to be press-fitted).