About this 3D model

A little words before Side Mount Spool Holder from @ryan.fransen is great, However i found it's up-right corner (top-front after installation) is not handling any strength, that means filament wastage. And personally i want it more clean look, So i make some changes. Additionally, Voron Style Spool Holders are added, some PFTE tube can turn into a very smooth roller, try it out! Boost Me Highlight of this remix: 85% filament usage compare to original on identical settings . Strong and durable design. Compatible with original parts (notice screw thread is left hand) Added Voron Style Spool Holders (use PFTE as roller) Adaptor for holding filament directly, or use a PC4-M10 fitting like original. Better sharp and angle optimization for better installation result. Print guideline: Main Body: use 3 walls, 20% infill, use a typical brim. AMS Lite Rotary/Basic Spindle Adapter: use 3 walls, 30% infll. One tube roller: use 4 walls, 40% infill plus, print it vertically. Two tube roller: use 3 walls, 30% infill minimal, print it laying down. Note: PETG or PLA+ are recommend. Cut the PFTE to 83mm length. The side mount uses four M3x12mm Hex bolts. Updated 22/3/2024 Side Mount Spool Holder V1 is functionally perfect, but the supports bothered me. After days of rethinking and tweaking, V2 is finally here, No Supports needed any more! * No need to reprint if you are currently using V1, as the functionality remains the same. * V2 无需任何支撑 ，如已在使用 V1，无需重新打印，功能相同。 写在前面的话： @ryan.fransen 的侧料架很棒，但我发现它的右上角根本不受力，白白浪费了材料，而且我个人更喜欢简单的设计，所以我对这个模型进行了一些修改。另外，我新增加了 Voron 的风格的滚筒，这样你不需要采购任何额外的零件，只需要一些备用的 PFTE 管就可以尽享丝滑。 这个 Remix 的一些亮点： 对比原作同样设定下仅 85% 材料消耗，足够强韧和耐用的设计。 兼容原作者的配件（原作已更新逆时针螺纹而有些二创并未适配） 添加了使用 PFTE 管作为滑动面的 Voron 风格滚筒。 新增进料管固定配件，不像原作必须使用 PC4-M10 气动头。 主体部件转角并非90度而是89度，螺丝拧紧后更贴合。 打印建议： 主体：3墙，20%填充，外部 Brim。 AMS Lite Rotary 轴和原厂料架转接器：3墙，30%填充。 Voron 滚筒单管版：纵向打印，加 Brim，4墙，40%填充 Voron 滚筒双管版：横向打印，3墙，30%填充 注：建议 PETG 或 PLA+，PFTE 管裁切长度为 83 mm