About this 3D model

Boost Me I would be delighted if you appreciate the model and give it a boost. 24.03.2024 * GERMAN * According to a user, there was a problem with the purge amount. This has now been rectified! Additionally, there is a new model (5-11) where the cutouts for the hygrometer holder are offset by 30°. Almost like a clock. My original model had these cutouts at 6 and 12 o'clock. The additional model now has them at 5 and 11 o'clock. * ENGLISH * According to a user, there was a problem with the purge amount. This has now been fixed! In addition, there is a new model (5-11) in which the notches for the hygrometer holder is offset by 30°. Almost like a clock. My original model had these notches at 6 and 12 o'clock. The additional model now has them at 5 and 11 o'clock. ORIGINAL POST: *** GERMAN *** I wanted to have a small stand for an inexpensive hygrometer (Ali****, Te**, Ama***), which fits in the front center of my AMS. I wanted it to have a logo to match the AMS. Of course, you can also use the holder without the AMS and place the hygrometer on your desk, for example, or in your home in general. The holder can also be removed if filament rolls are used in the AMS. The logo belongs to Bambu Lab and I do not want to give the impression that this is an official Bambu Lab model! *** ENGLISH *** I wanted to have a small stand for an inexpensive hygrometer (Ali****, Te**, Ama***), which fits in the front center of my AMS. I wanted it to have a logo to match the AMS. Of course, you can also use the holder without the AMS and place the hygrometer on your desk, for example, or in your home in general. The holder can also be removed if filament rolls are used in the AMS. The logo belongs to Bambu Lab and I do not want to give the impression that this is an official Bambu Lab model!