About this 3D model

A relatively complete Steam Deck expansion dock + stand two-in-one back clip, compatible with Daiji HC6022D card expansion dock, can be received for about sixty yuan on e-commerce platforms, and then paired with common Steam Deck one male and one female U-shaped typec conversion line, can achieve a very elegant level. Note: This back clip blocks one of the USB 3.0 ports of the expansion dock. Although it can be avoided by moving the model to one side, it will greatly increase the size of the model. After weighing the pros and cons, I chose the current occupation scheme. Under the current scheme, two USB 3.0 ports, one TYPE-C port that supports 100W fast charging, and one HDMI port are still retained. Remark 2: Four M2*10 positioning column pins need to be prepared as connecting parts, two as rotation pivots and two as rotation limiters. Remark 3: The actual picture model used Garilong photopolymerized nylon printing, which was found to be deformed in the actual test. After a round of repairs, it can be used, but it is still not recommended to use this method; it was also printed with petg version using fdm machine before, without deformation problem, but the surface finish depends on the machine and the nozzle. Remark 4: In fact, the currently selected U-shaped conversion line has a 11 mm spacing, which is still a little short. When the expansion dock is bare, the head is slightly cocked, but it is currently usable due to the tolerance of the interface. Let's see if there is a chance to get a 12 mm version of the conversion line later, which should be extremely elegant.