About this 3D model

INTRODUCTION This is a Parkside battery holder with 2 mounting holes. It holds up to 6 batteries. Can be mounted horizontally (in my application) or vertically if it suits you better. PRINTING I printed it with Ender 3 V2 (PLA, 0.2mm layer height, with supports). I recommend using 4 walls and tree supports . ASSEMBLY Use 2 screws (can be up to 6mm in diameter) to mount the holder to a wall. To make sure the print doesn't crack use large washers . USE Just push the battery in its slot until you hear the click . To take it out you need to press the same button that you press when pulling it out of your drill. Suggestions and improvement comments are always welcome :)