About this 3D model

INTRODUCTION This is improved Parkside charger holder with 2 mounting holes. Holds 1 battery charger. I printed it with Ender 3 V2. PRINTING I recommend printing it laying on the side (like on the last picture), with at least 4 walls and tree supports . ASSEMBLY Use 2 screws (can be up to 6mm in diameter) to mount the holder to a wall. To make sure the print doesn't crack use large washers . USE To insert the Parkside charger firstly insert the upper end (where the cable comes out of the charger) and then pres the lower end in. CAUTION: This mount is for older Parkside chargers… The new ones are bigger (on the first picture the left one is newer, you can see the size difference). Link to the bigger one: https://makerworld.com/en/models/743121-parkside-battery-charger-holder-mount-bigger#profileId-802612 Suggestions and improvement comments are always welcome :)