About this 3D model

This is a half sized model laid out in a print all parts at once single plate. While it's being printed on a Rostock Max with a round build plate, I've created this in a rectangle shape for wide support. I suggest printing this model with a brim of atleast 3mm or the small pins will have a hard time sticking to the build plate. If you use Cure for slicing, you may have to cut the brim from the pin holes of the gear parts as it tends to put the brim/skirt on the inside as well as the outside of the model edge. :( I'll be printing this model over night, stand by for updated pictures of the final make.