About this 3D model

This is a bracket that adapts this Raspberry Pi Acrylic Holder Case from Amazon to mount to the Official Creality Ender Enclosure. The original model can be installed by separating the poles from your enclosure and sliding it over the pole once disconnected. The tolerances are tight enough to maintain position and slide along the pole for height adjustment and rotation. I am currently redesigning it so it can snap over the pole without separating them. 2/27/2024 V2 STEP file available for snap fit onto pole without remove/replace. Creality Official 3D Printer Enclosure: https://a.co/d/cOjP3Sl Raspberry Pi Camera Module V2-8 Megapixel, 1080p (RPI-CAM-V2) : https://a.co/d/e2ZKOzf 100cm Raspberry Pi Camera Flex Ribbon Cable: https://a.co/d/hkNZ5RV Raspberry Pi Acrylic Holder Case: https://a.co/d/d4jSKNC (2) M3x10 screws: https://a.co/d/f0iP6RH (2) M3 Nuts