About this 3D model

V2 is out! check it out!: https://makerworld.com/en/models/436679#profileId-341845 Didn't tested it for it yet, but pretty sure it will work for bambu refills as well :) If you download the raw files and don't use my print profile, here are a few points to consider: - It is recommended to use: - At least 4 walls - At least 4 top layers - At least 4 bottom layers - 15% infill or more - For threaded parts, it MUST be printed at least at 0.15mm layer height, otherwise IT WILL NOT FIT (you can either print the entire model with this layer height or use adaptive layer height only for the threaded parts). - No supports are necessary.