About this 3D model

Bambu Lab Multi Filament Spool for A1 MINI ONLY Introduction A multi-filament drop-in replacement for the bambulab spool. This model is an adaptation for the A1 Mini Buildplate. You'll be able to insert up to 4 different filament in a single spool. Useful if you have samples or leftover on many spools. It is also available a 2 Filament Spool Version here What you'll need: Filament Clip To stop the filament from unwinding you'll need this filament clip : Assembly instructions twist the bambulab spool to open it in half align every spool disk as shown in the illustration, taking care to align the internal channels insert the dovetail stoppers (the 2 trapezoid pieces) inside the channels put together the bambulab spool and twist it back in position the 2 halves Correct order: N.B. Align all the holes as shown in the figure below Filament insertion Straighten up the end of the filament Fold at 90 degree angle the last 2-3 mm using a plier. Put the curved filament in the hole Start winding it mantaining tension on the spool for the first couple of turns