About this 3D model

I was able to slice with Arachne wall, but unable to upload because of the size. It did take my computer significant time to slice perhaps yours will be faster than mine. Remember to change the walls if you can. This print is only 1.5mm slightly thinner than normal. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA+ Esun Brown Transmission Distance: 1.5 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5 Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Brown At layer #10 (0.88mm) swap to Gray At layer #14 (1.2mm) swap to Jade White for the rest.