About this 3D model

When printing the buttons, very specific settings were chosen to make the center stem be a single wall with a lot of Arachne line width variance. This results in a stronger stem that won't snap. If using 0.4mm nozzle, this is less important. Printed on a P1S at 0.3mm layer height Line Width: 0.62 Scarf Seam: Contour and Hole Wall Gen: Arachne Wall Transitioning Threshold Angle: 59 Degrees Wall Transitioning Filter Margin: 100% Wall Transition Length: 100% Minimum Wall Width: 100% Minimum Feature Size: 0% Minimum Wall Length: 0% Wall Loops: 3 Shell Layers: 2 top layers and 3 bottom layers for 0.3mm layer height, adjust for other layer heights Bottom Surface Pattern: Monotonic Lines for cases and Concentric for buttons Infill: 20% Infill Pattern Gyroid