About this 3D model

The stand allowing you to comfortably and securely hold your mobile phone at the optimal viewing angle. Thanks to the worm gear, it can never happen that the stand with your mobile falls flat . Thanks to the combination of a worm gear with bevel gears , the stand enables easy and smooth tilting. Compatible with charger . It is not necessary to glue the parts here. (Otherwise I made a profile where there are parts with clearance. This version requires the use of glue) Smooth design Different colors can be used for mechanical parts (Profile: Divided into two plates - Different color). Assembly instruction: Instructions can be found in the video below. Please follow the procedure: ( video ) https://www.youtube.com/shorts/9PywQ-fwkmk Groove clearance problem : If there is too big clearance in the guide groove ( 02_Gear and 03_Base), it may happen that the 02_Gear tilts too much and the 01_Worm gear will not engage (the stand will not tilt). If this situation occurs, I recommend slightly pushing the left side of the 02_Gear and turning with the 06_Adjustable_Gear . A VERSION WITH CLEARANCE It may happen that main version will not be assembled due to small clearances. Actual clearance depends on many factors (flow, filament, printer condition) Parts with the letter C in their name are parts that have increased clearance. These parts must be glued